Installing Magicsafe - Waeco MagicSafe MS-670 Bedienungsanleitung

_MS-670.book Seite 37 Donnerstag, 8. Mai 2008 4:55 16
MagicSafe MS670
5.3 Possible operating modes of MagicSafe
The alarm system has the following three operating modes:
Stand-by
The alarm system is constantly on stand-by as soon as it is installed and
correctly connected. However, it does not trigger the alarm when in stand-
by.
Activation time
The alarm system has an activation time of approx. 40 seconds.
As an optical indicator of the activation time the LED is illuminated on the
control device (fig. 5 3, page 5).
Activated
If the alarm system is activated, it can trigger the alarm. This happens if
someone breaks into the door, opens the bonnet or enters the vehicle
interior. If you wish to drive off, you must first deactivate the alarm system.
The system is then in stand-by mode.
As an optical indicator for activation, the LED flashes on the control
device (fig. 5 3, page 5).
Alarm triggered
When an alarm has been set off, this is indicated by optical and acoustic
signals.
6

Installing MagicSafe

I
Note
If you do not have sufficient technical knowledge for installing and
connecting the components in vehicles, you should have a
specialist install the alarm system in your vehicle.
Installing MagicSafe
37