Light Sensitivity (Iso); Manual Partial Light Output (P) - Metz MECABLITZ 58 AF-2 Canon Bedienungsanleitung

6.5 Light sensitivity (ISO)

If there is no digital data transfer between the camera and flash unit, the ISO can
be manually set from 6 to 6400.
A
For flash modes (automatic) and
have to be set to the same ISO value.
Setting procedure:
• Press the
A F 8.0
hes on the LC display.
MZoom 35
12 m ISO 200
+
Para –
F 8.0 • Set the desired ISO value using the
A
MZoom 35 tons. The setting takes effect immediately.
17 m ISO 400
Para – +
• Press the button to change the LC display back to the normal view. If the
button is not pressed, the display will change back to the normal view
after about 5 seconds.
During E-TTL flash mode, setting the ISO on the flash unit is only necessary to
achieve the correct distance range indication, not for the function of the flash.
M
(manual), the camera and flash unit
button (Parameters) until „ISO" flas-
Para
+
–
/

6.6 Manual partial light output (P)

M
In the manual mode
adjusted to fit the shooting situation with the manual partial light output parame-
ter (P). Settings in manual flash mode M range from P 1/1 (full light output) to P
1/256, in intervals of 1/3.
Setting procedure:
• Press the button (Parameters) until „P" appears
Para
on the LC display.
• Set the desired light output (1/1-1/256) with the
but-
–
/ buttons. The setting takes effect immediately.
• Press the button to change the LC display back to
the normal view. If the button
display will change back to the normal view after
about 5 seconds.
In strobe mode , the maximum partial light output is automatically
adjusted to fit the flash parameters chosen.
In strobe mode , reduction of the manual partial light output is only
possible in full intervals.
When the number of flashes (N) and the flash frequency (f) are reset, the
partial light output is not reset.
and the strobe mode , the light output can also be
M
+
M
is not pressed, the
F 8.0
MZoom 35
6,1 m P1/8
+
Para –
F 8.0
MZoom 35
17 m P1/1
+
Para –
125