Partial Light Output (M) In M-Mode Settings On The Master Flash Unit; Remote Channel Settings - Metz Mecablitz 64 AF-1 digital - Canon Bedienungsanleitung

10.1.5 Partial light output (M) in M-mode
settings on the master flash unit
Set the mode to
REMOTE
M
1/1
MASTER
• Press the
I
A M 1/1
u
display as many times as it takes for the
I
B M 1/1
u
partial light output setting to appear.
I
C M 1/1
u
: :
A B C
O
• Press the sensor button on the touch
display for which a partial light output is to
P
A u M
1/1
be set (in the example, a partial light out-
P
B u M
1/1 put of 1/16 is to be set for slave group A).
P
C u M
1/1
O
EV
• Press the
1/8-2/3
touch display to set the desired partial light
1/16
output.
1/16- 1/3
p
q
• Press the sensor button of the selected par-
tial light output
REMOTE
M
MASTER 1/1
I
A M 1/1
u
I
B M 1/1
u
The setting is adopted automatically.
I
C M 1/16
u
: :
A B C
M
as described in 10.1.2.
A:B:C
sensor buttons on the touch
sensor buttons on the
1/16
on the touch display.

10.1.6 Remote channel settings

There are four independent remote channels
to use so that multiple remote systems in the
same room do not interfere with one another.
Master and Slave flash units belonging to the
same remote system must be set to the same
remote channel.
• Press the
for the selection menu to appear.
• Press the
PARAMETER
touch display.
PARAMETER O
• Press the
touch display.
ZOOM
RATIO
CHANNEL
O
CHANNEL
• Press the
touch display and select a remote channel,
CHANNEL 1
CHANNEL 2
e.g
CHANNEL 2
• Press the sensor button on the touch
CHANNEL 3
display for the desired channel.
p
q
The setting will take effect immediately.
The channel setting, CH2 in the example,
can be checked by pressing sensor button
i
.
D
button as often as it takes
PARAMETER
sensor button on the
CHANNEL
sensor button on the
sensor buttons on the
.
185
k