Yamaha DSP-E800 Bedienungsanleitung Seite 14

CONNECTIONS
Speaker cables
10 mm (3/8")
1
1
Remove approx. 10 mm (3/8") of insulation
from each of the speaker cables.
2
Twist the exposed wires of the cable together
to prevent short circuits.
Connecting to the REAR and
CENTER SPEAKERS terminals
Red: positive (+)
Black: negative (–)
1
Unscrew the knob.
2
Insert one bare wire into the hole in the side of
each terminal.
3
Tighten the knob to secure the wire.
E-12
2
2
1
3
Other connections
Using this unit as a Dolby Digital
or DTS decoder
Connect the OUTPUT terminals (MAIN, REAR, CENTER
and SUBWOOFER) of this unit to the EXTERNAL
DECODER or 6 CHANNEL input terminals of the external
amplifier.
Receiving the multi-channel signal
from other equipment
1
Be sure to move the EXTERNAL DECODER/
MAIN IN switch to the EXTERNAL DECODER
position before you turn on this unit.
2
Connect the OUTPUT terminal of the external
amplifier to the 6CH INPUT terminals of this
unit.
3
Press TAPE/MD MON / 6CH INPUT repeatedly
(or 6CH INPUT once) until "6CH INPUT"
appears on the display.
• The signal on the main channel will be output to the
MAIN OUTPUT terminals.
• The overall volume level will be controlled by DSP-
E800.
Using this unit as a power
amplifier
1
Be sure to move the EXTERNAL DECODER/
MAIN IN switch to the MAIN IN position before
you turn on this unit.
2
Press TAPE/MD MON / 6CH INPUT repeatedly
(or 6CH INPUT once) until "6CH INPUT"
appears on the display.
• DSP-E800 is regarded as 3-channel power amplifier.
The REAR L, the REAR R, and the CENTER
terminals can be used for the connection.
• The volume control of this unit will be bypassed.