Interacoustics AD629 Gebrauchsanweisung Seite 17

AD629 Instructions for Use - EN
6 Masking / Channel 2
7-14 Function Keys
15 Shift
16 Temp Setup
17 Setup /
Tests
18 Delete /
del curve
19 Save Session/
New Session
20 Print
21 Talk Forward
22 Tone / Warble
23 Wavefile
24 Mic
Indicates masking or Intensity level for channel 2, e.g.:
These keys are context sensitive and depend on the selected test
screen. Will be further explained in the sections describing the
individual tests
.
The shift function will enable the clinician to activate the sub
functions written in italic underneath the buttons.
Allows the clinician to make temporary changes in certain settings
within each test. To save the changes as default (for the next
session) press "Shift (15)" and then
between the different settings using the right rotary wheel (43).
Change the individual settings using the left rotary wheel (41).
The common setting menu can be accessed for more specific tests
and changes to general settings can be made. This is also where
the special tests are accessed: Auto tests (HW, Békésy), MHA,
SISI. To save the changes as default (for the next session) press
"Shift (15)" and then
different settings using the right rotary wheel (43). Change the
individual settings using the left rotary wheel (41).
Delete points during testing delete. Delete the entire test curve of a
graph by holding "Shift (15)" together with this button.
Saving a session after testing or alternatively add a new session by
holding the "Shift (15)" together with this button. (A new session will
recall the default settings saved in 16 and 17)
Allows results to be printed directly after testing (via a supported
USB printer).
Instruction to the patient directly through his headphones via the
microphone can be given. The intensity changes by turning the
"HL dB" (41) while holding the "Talk Forward" button.
Pure tones or warble tones can be chosen as stimuli by activating
this button once or twice. The stimuli chosen will be shown on the
display, e.g.:
Enables one to perform speech testing using loaded wavefiles, i.e.
pre-recorded speech material. Please see setup under Temp
Setup (15). Requires installation of speech material.
For live speech testing through the microphone (1). The VU meter
can be seen on the display screen. Adjust the microphone gain by
holding down the Mic button for one second.
(14). Choose
(14). Choose between the
Page 11