Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
STUDER 4729
Example:
if
the user
has
defined cue data for
track 5 but only the minutes field of
a
time offset into track 5 has been specified, then any cue entry key would generate
a
cue point
of
track
5,
time offset X minutes, 0 seconds,
0
frames. This would then
be used
as
the current cue point. X
is
the offset in minutes defined by the
user.
CUE
ENTRY
type keys
are:
END_CUE
1241,
CC
ENTRY
[26j, CUEWHEEL [28], and FAST DIAL
[2e]
3.5
Test Modes
Display
test
Display software
version
Display
module numbers
EEPROM
delete
Entering
the
DISPI-AY
TEST
mode will
turn all the
LEDs
of
the
controller ON. To
enter
the
mode,
the controller must be powered ON keeping the numerical
key
0
down
on the edit
module.
The display test
will
remain
active until the key
is
released.
The
mode is entered when the controller is powered up with
the
DRIVE
SELECT
1
key hold down and it remains active
until
the key is
released.
The module numbers can be displayed
on
each command module when
the
controller
is
powered
up with the TIME key of the edit module held down.
The
display
will remain active
until
the TIME key
is
released.
The
whole
EEPROM
can be cleared (filled up with 0s)
when both the
CLEAR
and
the
DISC REC
keys are pressed together
during power up
of
the controller.
CAUTION: this will clear all stored data required
for disc recognition!
This action takes approx. 50 seconds.
EDITION:
1
8.
Oldobe|l
ggo
E 3123
Werbung
Inhaltsverzeichnis
