Multi Zone Music Entertainment System - Denon AVR-2803 Bedienungsanleitung

Multi-zone playback with multi-source

MULTI ZONE MUSIC ENTERTAINMENT SYSTEM

• When the outputs of the "ZONE 2" OUT terminals are wired and connected to integrated amplifiers installed
in other rooms, different sources can be played in rooms other than the main zone in which this unit and the
playback devices are installed. (Refer to ZONE 2 on the diagram below.)
• ZONE 2 SPEAKER OUT can be used when "ZONE2" is selected at System Setup Menu "Power Amp
Assignment". In this case, Surround Back Speaker OUT cannot be used for MAIN ZONE. (See page 14.)
NOTES:
• For the AUDIO output, use high quality pin-plug cords and wire in such a way that there is no humming
or noise.
• For instructions on installation and operation of separately sold devices, refer to the devices' operating
instructions.
2 MULTI ZONE MUSIC ENTERTAINMENT SYSTEM (When using PREOUT)
ZONE 2 MAIN ZONE
B
B
INTEGRATED AMPLIFIER
AVR-2803
SYSTEM REMOTE
CONTROL UNIT RC-925
2 MULTI ZONE MUSIC ENTERTAINMENT SYSTEM (When using SPEAKER OUT)
ZONE 2 MAIN ZONE
B
AVR-2803
SYSTEM REMOTE
CONTROL UNIT RC-925
10 SURROUND
Before playing with the surround function
• Before playing with the surround function, be sure to use the test tones to adjust the playback level from the
different speakers. This adjustment can be performed with the system setup (see page 12) or from the remote
control unit, as described below.
• Adjusting with the remote control unit using the test tones is only possible in the "Auto" mode and only
effective in the DOLBY/DTS SURROUND modes. The adjusted levels for the different modes are automatically
stored in the memory.
1
2
ZONE 2 AUDIO signal cable
SPEAKER cable
3
* Refer to CONNECTIONS on pages 4 to 8.
• After adjusting using the test tones, adjust the channel levels either according to the playback sources or to
suit your tastes, as described below.
1
ZONE 2 SPEAKER cable
SPEAKER cable
* Refer to CONNECTIONS on pages 4 to 8.
2
When the surround back speaker setting is set
to "1spkr" for "Speaker Configuration", this is
set to "SB".
Press the TEST TONE button.
(Remote control unit)
Test tones are output from
the different speakers. Use
the channel volume adjust
buttons to adjust so that the
volume of the test tones is
the same for all the
(Remote control unit) speakers.
After completing the
adjustment, press the TEST
TONE button again.
(Remote control unit)
Select the speaker whose
level you want to adjust.
(Remote control unit)
The channel switches as shown below each
time the button is pressed.
FL C FR SR SBR SBL
SW SL
FADER
Adjust the level of the selected speaker.
(Remote control unit)
ENGLISH
2 2
1, 3
2 2
1
NOTES:
• The adjustment range for the different channels
is +12 dB to –12 dB.
• The sound from the subwoofer can be cut by
lowering the SW (subwoofer) setting one step
from –12 dB (setting it to "OFF").
27