Operating Denon Audio Components; Preset Memory - Denon AVR-2803 Bedienungsanleitung

ENGLISH

Operating DENON audio components

1
Use the mode selector buttons to select the component you want
to operate.
The function will change one step in the sequence described
below each time the MODE SELECT button is pressed.
CD CDR/MD TAPE
ZONE2 TV DBS/CABLE
2
Operate the audio component.
• For details, refer to the component's operating instructions.
It may not be possible to operate some models.
1. CD player (CD) system buttons
6, 7 : Manual search (forward and reverse)
2 : Stop
1 : Play
8, 9 : Auto search (to beginning of track)
3 : Pause
DISC SKIP + : (for CD changers only)
3. MD recorder (MD), CD recorder (CDR) system
buttons
6, 7 : Manual search (forward and reverse)
: Stop
2
1 : Play
8, 9 : Auto search (to beginning of track)
3 : Pause
Default setting : CDR
18
1
DVD/VDP
VCR
1
2. Tape deck (TAPE) system buttons
6 : Rewind
7 : Fast forward
2 : Stop
1 : Forward play
3 : Pause
0 : Reverse play
A/B : Switch between sides A and B
4. Tuner system buttons
TUNING +, – : Tuning up/down
BAND : Switch between AM and FM bands
MODE : Switch between AUTO and MANUAL
MEMORY

: Preset memory

SHIFT : Switch preset channel range
CHANNEL +, – : Preset channel up/down
RDS : RDS search
The tuner can be operated in the amplifier (CD, CDR/MD, or
TAPE) mode.
Preset memory
The included remote control unit can be used to operate devices of different brands by registering the preset
number corresponding to the brand of your device.
For some models the remote control unit or the device may not operate properly. In this case, use the learning
function (page 20) to store your device's remote control signals in the included remote control unit.
1
Press the power ON/SOURCE button and the
OFF button at the same time.
• The LEARNED/TX indicator flashes.
2
Press the mode button of the equipment that is
to be entered to a preset memory.
• The mode button flashes.
3
Referring to the included List
1 2 3
of Preset Codes, use the
4 5 6 number buttons to input the
preset code (a 4-digit
7 8 9
number) for the manufacturer
0
of the component whose
signals you want to store in
the memory.
4
When stored correctly, the mode button and
the LEARNED/TX indicator will light.
NOTES:
• Depending on the model and year of manufacture, this function cannot be used for some models, even if
they are of makes listed on the included list of preset codes.
• Some manufacturers use more than one type of remote control code. Refer to the included list of preset
codes to change the number and check it out.
• The preset memory can be set for one component only among the following: CDR/MD, DVD/VDP
and DBS/CABLE.
The preset codes are as follows upon shipment from the factory and after resetting:
TV, VCR......................................................................HITACHI
CD, TAPE ...................................................................DENON
CDR/MD ....................................................................DENON (CDR)
DVD/VDP ...................................................................DENON (DVD)
DBS/CABLE ...............................................................ABC (CABLE)
DVD preset codes 0000 0001
DVD-900
DVD-800
DVD-1000
DVD-1600
DVD-1500
DVD-2000
B
DVD-2800
Model No. DVD-2500
DVD-2800II
DVD-3000
DVD-3800
DVD-3300
DVD-A1
1 1
2
3
5
To store the codes of another component in the
memory, repeat steps 1 to 4.