Learning Function - Denon AVR-2803 Bedienungsanleitung

ENGLISH

Learning function

If your AV component is not a DENON product or if it cannot be operated using the preset memory, it can be
controlled with the included remote control unit by storing its remote control signals in the remote control unit.
For some remote control signals it is not possible to "learn" the signals or the device will not operate properly.
In such cases use the remote control unit included with the device to operate it.
1
Press the USE/LEARN button with the tip of a
pen etc., to set the learn mode.
• Both the mode selector buttons and
LEARNED/TX indicator flash.
Flashes
2 Press the mode button of the equipment for
which learning is desired.
• Mode button and LEARNED/TX indicator
flash.
3 Press the button that is to be learned.
The LEARNED/TX indicator stops flashing and
the mode button lights.
• Mode button and LEARNED/TX indicator
flashed if a button that cannot be "learned" is
pressed.
• To cancel, press the USE/LEARN button.
4
Point the remote control units directly at each
other and press and hold
in the button on the
other remote control
unit which you want
to "learn".
5 The mode button and the LEARNED/TX
indicator lights, release the button
on the other remote control unit.
• The mode button and the
LEARNED/TX indicator start
flashing again.
20
2
1, 3, 7
6
To "learn" other buttons, repeat steps 2 to 5.
7 Once the learning operation is completed, press
the USE/LEARN button again.
The mode button and the LEARNED/TX
indicator stop flashing and the learning mode is
cancelled.
Other remote
control unit
Check that the stored
codes work properly.
NOTES:
• If the codes could not be stored, the
LEARNED/TX indicator start flashing rapidly. For
limited number of models, codes cannot be
stored in RC-925.
• If the mode button and LEARNED/TX indicator
start flashing rapidly, this means that the
memory is already full, and the code you have
just attempted to store was not stored.
To "learn" that code, first perform the resetting
operation. (See page 21.)
System call
The accessorious remote control unit is equipped with "system call" function allowing a series of remote control
signals to be transmitted by pressing a single button.
This function can be used for example to turn on the amplifier's power, select the input source, turn on the
monitor TV's power, turn on the source component's power and set the source to the play mode, all at the touch
of a button.
(1) System call buttons
Up to 10 signals each can be stored at the
"CALL1" and "CALL2" buttons.
(2) Storing system call signals
1
Press the power ON/SOURCE button and the
OFF button at the same time.
• The LEARNED/TX indicator flashes.
2 Press the CALL 1 button.
• The mode selector buttons and LEARNED/TX
indicator flash.
3 Press the mode buttons of the equipment that
is to be registered to System Call.
4 Press the buttons whose remote control signals
you want to store one by one.
5 Repeat steps 3 and 4 to register the desired
buttons.
6 Press the CALL1 or CALL2 button and register
System Call.
(3) Using the system call function
1 Press the button at which the system call signals have been stored.
• The stored signals are transmitted successively.
1
1 1
3
2, 6
6
NOTES:
• The remote control signals for the buttons
pressed while storing the system call signals are
transmitted when the buttons are pressed, so
cover the remote sensor or take other measures
so that the components do not operate while
the signals are being stored.
• The mode button and LEARNED/TX indicator
flashing rapidly if you have already stored the
maximum number of signals.