Remote Control Unit (Rc-925) - Denon AVR-2803 Bedienungsanleitung

Surround parameters q
Pro Logic II Mode:
The Cinema mode is for use with stereo television shows and all programs encoded in Dolby Surround.
The Music mode is recommended as the standard mode for autosound music systems (no video), and is
optional for A/V systems.
The Dolby PL mode offers the same robust surround processing as original Pro Logic in case the source
contents is not of optimum quality.
Select one of the modes ("Cinema", "Music" or "Dolby PL").
Panorama Control:
This mode extends the front stereo image to include the surround speakers for an exciting "wraparound"
effect with side wall imaging.
Select "OFF" or "ON".
Dimension Control:
This control gradually adjust the soundfield either towards the front or towards the rear.
The control can be set in 7 steps from 0 to 6.
Center Width Control:
This control adjust the center image so it may be heard only from the center speaker; only from the left/right
speakers as a phantom image; or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.
DTS NEO:6 mode
• Surround playback can be performed for the analog input and PCM digital input 2-channel signals.
1 3, 5 1, 4, 6
1
Select the DTS NEO:6 mode.
SELECT
(Main unit) (Remote control unit)
2
Play a program source.
3
Set the surround parameter mode.
(Main unit) (Remote control unit)
The DTS NEO:6
Cinema or Music
mode can be chosen
directly by pressing
1
the CINEMA
MUSIC button on the
remote control unit
during playback in the
DTS NEO:6 mode.
3
4, 5, 6
This is the screen when operated with
the remote control unit.
4
Select the play mode.
SELECT
(Main unit) (Remote control unit)
Display
MODE cinema MODE music
5
Select the various parameters. (See "Surround parameters e" on page 33 for a description of the various
parameters.)
(Main unit) (Remote control unit)
6
Set the various surround parameters.
SELECT
or
(Main unit) (Remote control unit)
NOTE:
• When "Default" is selected and the 0 cursor button is pressed, "MODE" and "TONE" are automatically
reset to the default values and "CINEMA EQ" is set to "OFF".
ENGLISH
This is the screen when operated with
the remote control unit.
7
When the surround parameters are set using
the buttons on the main unit, stop operating
buttons after completing the settings. The
settings are automatically finalized and the
normal display reappears after several seconds.
When the settings are made using the buttons
on the remote control unit, press the
SURROUND PARAMETER button to finish.
29