Denon AVR-2803 Bedienungsanleitung Seite 28

ENGLISH
Fader function
• This function makes it possible to lower the volume of the front channels (FL, C and FR) or the rear channels
(SL, SR, SBL and SBR) together. Use it for example to adjust the balance of the sound from the different
positions when playing multi-channel music sources.
1
Select "FADER".
(Remote control unit)
The channel switches in the order shown
below each time this button is pressed.
FL C FR SR SBR
FADER SW SL
2
Press the 0 button to reduce the volume of
the front channels, the 1 button to reduce the
volume of the rear channels.
The fader function does
not affect the SW channel.
(Remote control unit)
The channel whose channel level is adjusted
lowest can be faded to –12 dB using the fader
function.
If the channel levels are adjusted separately after
adjusting the fader, the fader adjustment values
are cleared, so adjust the fader again.
Dolby Surround Pro Logic II
1 3, 5 1, 4, 6
1
Select the Dolby Surround Pro Logic II mode.
• The Dolby Pro Logic indicator lights.
SELECT
(Main unit) (Remote control unit)
Light Display
28
2
SBL
This is only displayed when setting the fader control.
mode
The Dolby Surround
Pro Logic II Cinema or
Music mode can be
chosen
1
pressing the CINEMA
or MUSIC button on
the remote control
unit during playback in
the Dolby Surround
Pro Logic II mode.
3
4, 5, 6
2
Play a program source with the
• For operating instructions, refer to the manuals of the respective components.
3
Set the surround parameter mode.
(Main unit)
The on-screen display differs according to whether the operation is
performed from the main unit or the remote control unit.
2
4
Select the play mode.
1
SELECT
(Main unit)
Display
MODE cinema
5
Select the various parameters. (See "Surround parameters q" for a description of the various parameters.)
(Main unit)
MODE CINEMA MODE MUSIC
CINEMA EQ
CENTER WIDTH
directly by
6
Set the various surround parameters.
SELECT
(Main unit)
NOTES:
• There are four Dolby Surround Pro Logic modes (NORMAL, PHANTOM, WIDE and 3 STEREO). The AVR-
2803 sets the mode automatically according to the types of speakers set during the system setup process
(page 10).
• Dolby Surround Pro Logic II is a mode in which 2-channel sources are expanded into 5.1 channels.
To output a surround back channel in this mode, set the "SB CH OUT" surround parameter to "NON
MTRX".
mark.
Display
MODE cinema
(Remote control unit)
(Remote control unit)
MODE music MODE DOLBY PL
(Remote control unit)
When set with the on-screen display using
the remote control unit while in the MUSIC
MODE DOLBY PL
mode, set the "
PANORAMA CINEMA EQ
using the • and ª cursor buttons, then press
the 0 cursor button.
DIMENSION
Press the ENTER button to return to the
previous screen.
7
When the surround parameters are set using
the buttons on the main unit, stop operating
buttons after completing the settings. The
settings are automatically finalized and the
normal display reappears after several seconds.
When the settings are made using the buttons
on the remote control unit, press the
(Remote control unit)
SURROUND PARAMETER button to finish.
This is the screen when operated with
the remote control unit.
This is the screen when operated with
the remote control unit.
" mark to "OPTION 0"