Installing Pci Board - Fujitsu FUTRO S400 Kurzanleitung

Short description

Installing PCI board

You can only install PCI boards with a maximum length of 150 mm.
► Make the required settings for the PCI board.
► Open the casing (see "Opening the casing").
1
2
3
Do not dispose of the rear slot cover plate. If you remove the PCI board again, you must
!
reinstall the rear slot cover plate due to cooling, fire protection and the EMC regulations
(regulations on electromagnetic compatibility) to be complied with.
1
2
English - 14
► Remove the riser card (1).
► Unscrew the screw (2) to remove the lock
4
located behind it.
► Unscrew the screws (3) and (4) to remove
the rear slot cover plate of the installation
slot from your device.
► Insert your PCI board on the riser card.
► Insert the riser card from the inside into the
installation slot and push it in the direction of
the arrow (1) until it perceptibly locks into
position.
► Secure the lock with the screw (2) to secure
the PCI board.
A26361-K522-Z123-1-7419, edition 2