Installing A Smartcard Reader - Fujitsu FUTRO S400 Kurzanleitung

Short description

Installing a SmartCard reader

If not already installed, you can fit a SmartCard reader.
Screwing SmartCard reader onto carrier
Fixing SmartCard reader onto device
English - 12
a
2
1
2
1
2
1
2
1
► Push the SmartCard reader - with the
component side facing downwards - in the
direction of the arrow (1) into the guide (a).
► Fasten the SmartCard reader with the
screws (2) onto the carrier.
► Open the casing (see "Opening the casing").
► Break off the plastic lock behind the plug-in
module on the front cover.
► Fasten the carrier with the screws (1) on the
casing cover.
► Connect the cable to the SmartCard
reader (2).
► Attach the cable to the connector (1) on the
mainboard and route it as shown in the
diagram (2).
► Close the casing (see "Closing the casing").
Make sure that the cables are not trapped
between the casing and the components.
A26361-K522-Z123-1-7419, edition 2