Fujitsu FUTRO S400 Kurzanleitung Seite 49

Short description
2
► Close the casing (see "Closing the casing").
Removing a module with a direct mainboard connector (e.g. DVI module)
► Open the casing (see "Opening the casing").
1
1
► Close the casing (see "Closing the casing").
Installing a module without a direct mainboard connector (e.g. WLAN module)
► Open the casing (see "Opening the casing").
1
Do not dispose of the cover of the bay. For cooling, protection against fire and in order to
!
comply with EMC regulations, you must refit the cover of the bay if you remove the
module.
English - 18
2
1
1
2
1
1
► Carefully push the module in the direction of
the arrow up to the stop (1).
► Secure the module with the screws (2) on
the holder plate.
► Unscrew the screws (1) from the holder
plate.
► Pull the module carefully out of the casing
in the direction of the arrow (2).
► Unscrew the screws (1) of the holder plate.
► Remove the holder plate.
► Refit the installation slot cover if you do not
want to install any other module.
► Unscrew the screws (1) and remove the
cover of the installation slot.
A26361-K522-Z123-1-7419, edition 2