Opening The Casing; Closing The Casing - Fujitsu FUTRO S400 Kurzanleitung

Opening the casing

If you want to upgrade your system, you must first open the casing.
► Switch off the device.
► Pull the power plug out of the mains outlet.
► Disconnect all cables of the device.
► Pull the device out of the base and lay it horizontally on a firm surface.
1
► Remove the two screws (1) and pull the front cover off to the front (2).
► Remove the two screws (3) on the rear of the device and lift off the casing cover (4).
Note that some components on the mainboard may be very hot if the device was in use
!
shortly before the casing was removed.
These components can be marked with the following symbol.

Closing the casing

► Replace the casing on the device and secure it in position with the two screws (3) at the rear of
the device. Make sure that the cables are not trapped between the casing and the components.
► Push the front cover onto the device and secure it in position with the two screws (1) at the
sides of the device.
► Slide your device into the base foot from the front toward the rear until it engages on the right-
hand side.
► Connect all the cables removed before.
A26361-K522-Z123-1-7419, edition 2
3
4
2
Short description
3
1
English - 11