Fujitsu FUTRO S400 Kurzanleitung Seite 50

Assembling the WLAN module
1
Installing WLAN module
► Turn the WLAN module over.
► From the inside, manoeuvre the WLAN module into the installation slot.
A26361-K522-Z123-1-7419, edition 2
1
3 2
1
1
2
1
► Push the WLAN board from the rear onto
the holder plate until the holes in the board
line up with the corresponding holes (1) of
the holder plate.
► Place the plastic cover (2) on the WLAN
board.
► Secure the plastic cover and the WLAN
board to the holder plate with the
screws (1).
► Connect the cable at the connector of the
WLAN board (3).
► From the outside, push the plastic cap over
the projecting end of the WLAN module.
► Secure the WLAN module and the plastic
cap with the screws (1).
► Attach the cable to the connector (1) on the
mainboard and route it as shown in the
diagram (2).
► Close the casing (see "Closing the casing").
Make sure that the cables are not trapped
between the casing and the components.
Short description
English - 19