Installing And Removing Modules - Fujitsu FUTRO S400 Kurzanleitung

1
2
3
► Close the casing (see "Closing the casing").

Installing and removing modules

You can fit a module (e.g. WLAN module or DVI module) in the installation slot.
Installing a module with a direct mainboard connector (e.g. DVI module)
► Open the casing (see "Opening the casing").
1
Do not dispose of the cover of the bay. For cooling, protection against fire and in order to
!
comply with EMC regulations, you must refit the cover of the bay if you remove the
module.
► Insert the holder plate supplied with the module into the casing and secure it with the
screws (1).
► Insert the module from above into the casing so that it sits on the screw holes of the holder
plate. Make sure that the connector on the underside of the module lies up against the
corresponding connector on the mainboard.
A26361-K522-Z123-1-7419, edition 2
►
4
►
►
►
1
Insert the riser card in its slot (1) again.
Secure the lock with the screw (2).
Reinstall the rear cover by inserting it in the
installation slot from the inside and securing
it with the screws (3) and (4) on the back of
the unit.
Unscrew the screws (1) and remove the
cover of the installation slot.
Short description
English - 17