System Expansions; Information About Boards - Fujitsu FUTRO S400 Kurzanleitung

Short description

System expansions

You can also install the following optional components:
● a PCI board (maximum length of 155 mm)
● a module
As the device has to be shut down in order to install/deinstall system hardware
i
components, it is a good idea to print out the relevant sections of this chapter.
It may be necessary to update the BIOS when carrying out a system expansion or
hardware upgrade.
When installing components that become very hot, make sure that the maximum
permissible temperature is not exceeded.
Observe the safety precautions in the "Safety" manual.
!
The device must be switched off when installing/removing the system expansions and may
not be in the energy-saving mode.
Remove the power plug before opening the device.
This chapter describes all activities you must carry out when you want to make changes to the
hardware of your device (e.g. install boards).
Read the supplied documentation before installing new modules and/or boards.

Information about boards

Take care with the locking mechanisms (catches and centring pins) when you are replacing boards
or components on boards.
To prevent damage to the board or the components and conductors on it, please take care when you
insert or remove boards. Make sure expansion boards are inserted straightly.
Never use sharp objects (screwdrivers) for leverage.
English - 10
Boards with electrostatic sensitive devices (ESD) are identifiable by the label
shown.
When you handle boards fitted with ESDs, you must, under all
circumstances, observe the following points:
● You must always discharge static build up (e.g. by touching a
grounded object) before working.
● The equipment and tools you use must be free of static charges.
● Always hold boards with ESDs by their edges.
● Never touch pins or conductors on boards fitted with ESDs.
A26361-K522-Z123-1-7419, edition 2