Fujitsu FUTRO S400 Kurzanleitung Seite 40

The following settings are possible:
Network Boot Protocol:
Boot Order:
Show Config Message:
Show Message Time:
The settings are not effective until after saving and another PXE system start-up.
A26361-K522-Z123-1-7419, edition 2
PXE (standard) or RPL
Int 19h
PnP/ BEV (BBS)
ROM Disabled
Int 18h
The following message can be activated or deactivated during the system
start-up:
Realtek RTL8139(X)/8130/810X Boot Agent
Press Shift-F10 to configure .......
Indicates the time in seconds for which the following message is displayed
during the system start-up:
Realtek RTL8139(X)/8130/810X Boot Agent
Press Shift-F10 to configure .......
Specification of the system start-up protocol
used.
The network is always started first before the
local devices are activated.
If a BBS-BIOS (BIOS Boot Specification) exists,
the system is started by the BBS-BIOS.
The entire mechanism for the system start-up is
deactivated. The system can only be activated
via the local devices.
The devices set in BIOS-Setup are enabled.
Short description
English - 9