Replacing Lithium Battery - Fujitsu FUTRO S400 Kurzanleitung

Replacing lithium battery

In order to permanently save the system information, a lithium battery is installed to provide the
CMOS-memory with a current. A corresponding error message notifies the user when the charge is
too low or the battery is empty. The lithium battery must then be replaced.
Incorrect replacement of the lithium battery may lead to a risk of explosion!
!
The lithium battery may be replaced only with an identical battery or with a type
recommended by the manufacturer. Contact our customer service centre.
Do not throw lithium batteries into the household waste. They must be disposed of in
accordance with local regulations concerning special waste.
Make sure that you insert the battery the right way round: The plus pole must be on the
top!
The lithium battery holder exists in different designs that function in the same way.
1
► Open the casing (see "Opening the casing").
► Press the catch in the direction of the arrow (1).
The battery jumps out of the holder slightly.
► Remove the battery (2).
► Push the new lithium battery of the identical type into the holder and press it downward until it
engages.
► Close the casing (see "Closing the casing").
A26361-K522-Z123-1-7419, edition 2
2
2
3
Short description
3
English - 21