Suzuki RV125K3 Montageanleitung Seite 16

RIGHT/DROIT/RECHTS
LEFT/GAUCHE/LINKS
FRONT
AVANT
VORNE
FRONT
AVANT
VORNE
15
With the screw not tightened, insert the balancer
sub-assembly into the handlebar end all the way, then
tighten the screw securely.
Check to ensure that the throttle operates
freely and closes automatically.
A: Balancer assembly
CLAMP
Clamp the right switch wiring harness and handlebar
with strap as shown in the photograph.
NOTE:
Cut the remaining of the strap as shown in the
photograph.
A: Strap L:140 mm
B: Handlebars
C: Right switch wiring harness
Clamp the left switch wiring harness and handlebar
with strap as shown in the photograph.
NOTE:
Cut the remaining of the strap as shown in the
photograph.
A: Strap L:140 mm
B: Handlebars
C: Left switch wiring harness
FRONT TURN SIGNAL LIGHT (RIGHT AND LEFT)
Remove the flange bolt.
Install the front turn signal light to the front fork lower
bracket.
Front fork lower bracket bolt:
A: Flange bolt
B: Front fork lower bracket
C: Front turn signal light
33 N·m (3.3 kgf-m)