Inhaltsverzeichnis
Werbung
THROTTLE
Insert the boss of the throttle upper housing into the
hole on the handlebars.
Tighten the throttle assembly with two screws.
Check to ensure that the throttle operates
freely and closes automatically.
A: Boss
B: Hole
C: 5 × 50 mm screw
D: 5 × 30 mm screw
FRONT BRAKE MASTER CYLINDER
Install the front brake master cylinder onto the han-
dlebars. Align the dot mark on the handlebars with
the master cylinder-to-holder fitting surface. Tighten
the master cylinder mounting bolts to the specified
torque.
Front brake master cylinder mounting bolt:
NOTE:
To install the holder correctly, first tighten the
bolt C C C C of the upper side with specified torque
and then tighten the bolt D D D D of the lower side.
A: Master cylinder
B: Holder
C: Flange bolt
D: Flange bolt
E: Dot mark
NOTE:
Install the holder in position according to the
mark "UP".
Make sure that the holder has no clearance at
the upper side as shown.
Check for brake fluid leakage.
A: Bolt
B: Holder
C: Master cylinder
D: Handlebars
9
10 N·m (1.0 kgf-m)
Werbung
Inhaltsverzeichnis
