Kessel Aqualift F Anleitung Für Einbau, Bedienung Und Wartung Seite 51

Installing the chamber seals / gaskets
Each chamber section is connected using a gasket (the size
of this gasket will vary depending on if an 800 or 1000 cham-
ber is being installed and on the specific section being in-
stalled). The recessed area for the gasket (located on the top
of each section as seen in the illustration) should be clean
and free from all debris / sand. Firmly place the gasket into
the recessed area of the chamber using a hand or a rubber
mallet. The upper exposed portion of the gasket should now
be lubricated with a standard gasket lubricant..
Access step installation
Access steps (included with KESSEL 1000 chamber,
available as accessory with KESSEL 800 chamber) may be
installed prior to assembling the individual chamber sec-
tions. Steps are installed as shown in the diagram below.
4. Installation
Installing chamber sections
Now place the next chamber section on top of the other ma-
king sure that the location for access steps are in line with the
lower portion. The steps should be in a left / right / left / right
pattern to aide in accessing the chamber after installation is
complete. If connected properly the 600mm open access to
the chamber in the cone section should be directly above (in
line with) the access steps. Connect the two chambers sec-
tions with the supplied clipping systems as seen in the illust-
rations.
Installing the vertically adjustable upper sections
51
• Firmly insert cu-
stom gasket into
recessed area of
cone section -
using a rubber
mallet if required
• Lubricate interior
exposed portion
of the gasket, ins-
ert upper section
and secure with
clamping ring.
• Final elevation /
slope adjust-
ments can be
made with the 3
adjustment scr-
ews which should
be upside down
(screws heads
should be at bot-
tom – threads
pointed upward)