Faults - Kärcher HDS 995 M Eco Bedienungsanleitung

Display
Necessary maintenance jobs
Remove the soot from the heating coil
(Customer Service)
Remove the calciul deposits from the
heating coil (Customer Service).
Clean/ replace ignition electrodes (Cus-
tomer Service).
Clean/ replace burner nozzle (Custom-
er Service).
Adjust burner (Customer Service)
Display
Necessary maintenance jobs
Check overflow valve of the pump for
leaks (Customer Service).
Check high-pressure hose (Customer
Service).
Clean hand-spray gun.
Check pressure accumulator (Custom-
er Service).
Clean the sieve in the water connection
Figure 1 - Pos. 19
Take out sieve.
Clean sieve in water and reinstall.
Cleaning the fine filter
Figure 10
Unpressurize the appliance.
Unscrew lid with filter.
Clean the filter with clean water or com-
pressed air.
Reinstall in reverse sequence.
Clean sieve in the water shortage safe
guard
Figure 11
Loosen covering nut and take off hose.
Figure 12
Take out sieve.
30
English
Note
If necessary turn in screw M8 appr. 5 mm
inwards and therewith pull out sieve.
Clean sieve in water.
Push sieve inwards.
Put on hose.
Tighten covering nut firmly.
Clean filter at the detergent suck hose
Figure 13
Take out detergent suck supports.
Clean filter in water and reinstall.
Oil change.
Figure 14
Ready a catch bin for appr. 1 Liter oil.
loosen release screw.
Dispose of old oil ecologically or turn in at
a gathering point.
Tighten release screw.
Fill oil slowly up to the MAX marking.
Note
Air pockets must be able to leak out.
For oil type refer to technical specifica-
tions.

Faults

Indicator lamp: Engine/ Electronics
is blinking
Figure 2 - Pos. 7
This indicator lamp blinks if there is a mal-
function.
Rectify the fault.
Turn on the appliance again. Indicator
lamp goes off.
Display
Troubleshotting
Increase water flow quantity.
Clean the sieve in the water connection.