Kärcher HDS 995 M Eco Bedienungsanleitung Seite 32

Note
By dismantling the high pressure hose from
the high pressure connection the venting
process is accelerated.
If detergent tank is empty, refill.
Check connections and conduits.
– Pressure is set to MIN
Set pressure to MAX.
– Sieve in the water connection is dirty
Clean sieve.
Clean the fine filter; replace it, if neces-
sary.
– Amount of water supply is too low.
Check water supply level (refer to tech-
nical data).
High pressure side is leaky
– Pump leaky
Note
3 drops/minute are allowed.
With stronger leak, have device
checked by customer service.
Device turns on and off while hand
spray gun is closed
– Leak in the high pressure system
Check high pressure system and con-
nections for tightness.
Device is not sucking in detergent
Leave device running with open deter-
gent dosage valve and closed water
supply, until the swimmer tank is sucked
empty and the pressure falls to "0".
Open the water supply again.
If the pump still is not sucking in any deter-
gent, it could be because of the following
reasons:
– Filter in the detergent suck hose dirty
Clean filter.
– Backflow valve stuck
32
English
Figure 15
Remove the detergent hose and loosen
the backflow valve using a blunt object.
Burner does not start
– Fuel tank empty
Refill.
– Water shortage
Check water supply, check connec-
tions, clean water shortage safeguard.
– Fuel filter dirty
Change fuel filter.
– Direction of rotation is wrong. With cor-
rect direction of rotation a strong airflow
can be felt out of the exhaust opening of
the burner.
Figure 16
Check direction of rotation. Exchange
the poles at the device plug, if required.
– No ignition spark
If device is in use and no ignition spark
can be seen through the viewing glas,
have device checked by customer serv-
ice.
Set temperature is not achieved
while using hot water
– Working pressure/flow rate to high
Reduce working pressure/flow rate
through regulating spindle (Figure 9).
– Sooty heating spiral
Have device de-sooted by customer
service.
If malfunction can not be fixed, the de-
vice must be checked by customer serv-
ice.