Installing The Handle; Water Connection; Power Connection - Kärcher HDS 995 M Eco Bedienungsanleitung

Install the hand-spray gun and hose
drum (appliances with hose drum)
Connect ray tube with hand spray gun
Insert high pressure nozzle into cover-
ing nut
Install covering nut and tighten firmly
Figure 4
Install the hose drum with the enclosed
screws, discs and nuts (4 pieces each).
Figure 5
Connect the high pressure hose to the
high pressure connection point of the
hose drum and the appliance.
Connect the high pressure hose of the
hand-spray gun to the hose drum.
Wind the high pressure hose with the
least possible bends (in the clock-wise
direction) on the hose drum.
Warning
Roll off the high-pressure hose from the
hose-drum completely while operating the
machine.
Installing spare high pressure hose
Figure 6

Installing the handle

Figure 7

Water connection

For connection values refer to technical
specifications
Figure 1 - Pos. 19
Connect the supply hose to the water
connection point of the machine and at
the water supply point (for e.g. a tap).
Note
The supply hose is not included.
suck in water from vessel
If you want to suck in water from an external
vessel, the following modification is neces-
sary:
Remove water connection from the
pump head.
Unscrew the upper supply hose with the
fine filter to the swimmer container and
connect it to the pump head.
Connect suction hose (minimum diame-
ter 3/4") with filter (accessory) to the wa-
ter connection point.
– Max. suck height: 0.5 m
Until the pump sucked in water, you should:
Turn the pressure and quantity regula-
tion to MAX.
Close the dosing valve for the deter-
gent.
Danger
Never suck in water from a drinking water
container. Never suck in liquids which con-
tain solvents like lacquer thinner, petrol, oil
or unfiltered water. The sealings within the
device are not solvent resistant. The spray
mist of solvents is highly inflammable, ex-
plosive and poisonous.

Power connection

For connection values, see technical data
and type plate.
Warning
The highest allowed net impedance at the
electrical connection point (refer to techni-
cal data) is not to be exceeded.
Warning
Check direction of rotation of the engine at
every socket change.
– With correct direction of rotation a
strong airflow can be felt out of the ex-
haust opening of the burner.
Figure 16
Exchange the poles at the device plug if
the rotation direction is wrong .
25
English