Operation - Kärcher HDS 995 M Eco Bedienungsanleitung

If you have to use an extension chord,
then the same must always be rolled up
and have an adequate cross-section.

Operation

Warning
Never operate device with empty fuel tank
The fuel pump will otherwise be destroyed.
Turning on the Appliance
Figure 2 - Pos. 1
Set the appliance switch to "I".
Indicator lamp for operational readiness
lights up.
Note
The temperature regulator must be at "0"
position because otherwise the burner will
switch off.
The device starts briefly and turns off, as
soon as the working pressure is reached.
Note
If the indicator lamps for fuel, liquid softner,
detergent or engine/ electronics are on dur-
ing operation, turn off device immediately
and repair malfunction, refer to malfunc-
tions.
Figure 8
Release the hand spray gun (A).
When activating the hand spray gun the de-
vice switches back on.
Note
If no water comes out of the high pressure
nozzle, vent pump. Refer to malfunctions
"Device is not building up pressure".
Adjust cleaning temperature.
Figure 2 - Pos. 2
Set temperature regulator to desired
temperature.
30 °C to 90 °C
– Clean with hot water.
100 °C to 150 °C
– Clean using steam.
26
English
Replace the high-pressure nozzle with
steam nozzle (refer "Using steam").
Set working pressure and flow rate
Appliance setting
Figure 9
Turn the regulation spindle in a clock-
wise direction: Increase working pres-
sure (MAX).
Turn the regulation spindle in an anti-
clockwise direction: Reduce working
pressure (MIN).
Servo pressure regulation
Set thermostat to max. 98 °C.
Set the operating pressure on the appli-
ance to the maximum value.
Figure 8
Set working pressure and flow rate
through turning (directly) at the pres-
sure- and amount regulation (B) of the
handgun (+/-).
Note
For long term work with low pressure, set
pressure at device.
Operation with detergent
– For considerate treatment of the envi-
ronment use detergent economically.
– The detergent must be suitable for the
surface to be cleaned.
Figure 2 - Pos. 10
With support of the detergent dose
valve set detergent concentration as
determined by the manufacturer.
Note
Recommended value at maximum working
pressure.
Cleaning
set pressure/temperature and detergent
concentration according to the surface
to be cleaned.