Operating; Configuration - WIKA CPH6300 Betriebsanleitung

6 Commissioning, Operation
6.2

Operating

Connect sensors, turn device on via
After segment test
if standard measurement is selected
if fast measurement is selected
if peak value detection is selected
After that the device is ready for measuring.
6.3

Configuration

Some menu points depend on current device settings (e.g. some menu points are
locked, if the logger memory contains data sets).
To change device settings, press "MENU"
menu (main display: "SEt"). Pressing "MENU"
jumps to the referring parameters. The parameters can be changed with
through the parameters with
Pressing "MENU" again jumps back to the main configuration menu and saves the settings.
"STORE" finishes the configuration and returns to standard measuring operation.
Pressing "MENU" and "STORE" at the same time for more than 2 seconds will reset
the device to factory defaults.
If there are data sets stored and logger is set to "manual recording" ("Func Stor") the
first menu point displayed is "rEAd Logg" (see chapter 6.5 "Data Logger")
If no key is pressed for more than 2 minutes the configuration will be aborted. All
changes will not be saved!
WIKA Operating Instruction, Model CPH6300
key.
the device displays some configuration:
for 2 seconds. This will activate the configuration
changes between the menus points, pressing
.)
GB
or . (Switch
13