WIKA CPH6300 Betriebsanleitung Seite 22

6 Commissioning, Operation
One data set contains: (1-channel version):
Measuring value at the time of the recording
■
"CALC off":
■
GB
"CALC aktiv"
■
Time and date of the recording
■
One data set contains: (2-channel version):
Sensor 1: measuring value at the time of the recording
■
Sensor 1: min-peak, max-peak since the last recording
■
Sensor 2: measuring value at the time of the recording
■
Sensor 2: min-peak, max-peak since the last recording
■
Difference sensor 1-sensor 2: measuring value at the time of the recording
■
"CALC off":
■
"CALC aktiv"
Time and date of the recording
■
b) Read manual recordings:
Saved data sets can be viewed both with Software GSOFT and directly on the device display.
Do not change the pressure sensor if manual recording is selected and values are
already stored, because otherwise invalid data may be read-out. The pressure
sensor used during the recording has to be connected!
Press for 2 seconds:
„rEAd LoGG" is only displayed if data sets have been already stored. Otherwise the
configuration menu is displayed:
or
1)
CALC-Function: see chapter 6.4.5
22
min-peak, max-peak since the last recording
1)
: Calculated value at the time of the recording and dummy value
is displayed if logger storage is full.
Difference sensor 1-sensor 2: min-peak, max-peak since the last
recording
1)
: Calculated value at the time of the recording and dummy value
is displayed if logger storage is full.
is displayed
Press shortly: Change between measuring values, measuring point and
date+time of the data set
Change between different data sets
End display of recordings
WIKA Operating Instruction, Model CPH6300