WIKA CPH6300 Betriebsanleitung Seite 17

6 Commissioning, Operation
Menu Parameter Value
Set Alarm: Settings for alarm function
On/No.So
OFF
Sensor1-Min
... AL.1-Hi
AL.1-Lo ...
Sensor1-Max
On/No.So
OFF
Sensor2-Min
... AL.2-Hi
AL.2-Lo ...
Sensor2-Max
On/No.So
OFF
-19999 ...
AL.DIF-Hi
Sensor-Min
... AL.Hi
AL.DIF-Lo ...
19999
AL.Lo ...
Sensor-Max
Set Logger: Settings for logger function
Selection of logger function
CYCL
Stor
oFF
0:01 ... 60:00
on/oFF
Set Clock: Settings for real time clock
HH:MM
YYYY
TT.MM
rEAd Logg: Read calibration data:
seechapter 6.5.1
(*) If logger memory contains data sets parameters marked with (*) cannot be called. You have to
clear memory to change these parameters! (see chapter 6.5)
(**) Parameter can only be called if corresponding sensor is plugged to connection 1. The settings
are applied to the sensor at connection 2 (if any connected).
(***) Only 2-channel version
WIKA Operating Instruction, Model CPH6300
Description
or
Alarm Sensor 1 on, with/without buzzer
No alarm function for Sensor 1
Min-alarm-limit sensor 1 (not if AL.1 = oFF)
Sensor1-Min is lower display range limit of sensor 1
Max-alarm-limit sensor 1 (not if AL.1 = oFF)
Sensor1-Max is upper display range limit of sensor 1
Alarm Sensor 2 on, with/without buzzer
No alarm function for Sensor 2
Min-alarm-limit sensor 2 (not if AL.2 = oFF)
Sensor2-Min is lower display range limit of sensor 2
Max-alarm-limit sensor 2 (not if AL.2 = oFF)
Sensor2-Max is upper display range limit of sensor 2
Alarm on, with/without buzzer (1-channel version) or
Alarm sensor difference on with/without buzzer
(2-channel version)
No alarm function (1-channel version) or
No alarm function for sensor difference (2-channel vers.)
Min-alarm-limit difference (not if AL.DIF = oFF)
Min-alarm-limit sensor (not if AL. = oFF)
Sensor-Min is lower display range limit of sensor
Max-alarm-limit difference (not if AL.DIF = oFF)
Max-alarm-limit sensor (not if AL. = oFF)
Sensor-Max is upper display range limit of sensor
Cyclic: cyclic logger
Store: manual recording
No logger activated
Cycle time in [minutes: seconds] (for cyclic logger)
Low-power-logger with low power consumption
(only for cyclic logger and slow measuring rate)
Clock: set time hours: minutes
Year: set year
Date: set date day. month
GB
***
***
*
*
*
*
17