Design And Function; Kurzbeschreibung / Beschreibung; Scope Of Delivery; Transport, Packaging And Storage - WIKA CPH6300 Betriebsanleitung

4 Design and Function / 5 Transport, packaging and storage

4 Design and Function

4.1

Kurzbeschreibung / Beschreibung

Because of the robust and waterproof design of the Hand-Held pressure indicator CPH6300, it is
suitable for though conditions. Due to the high accuracy of the Hand-Held pressure indicator
CPH6300 it can be used for precision measurements and calibration.
4.2

Scope of delivery

CPH6300 with 2 AAA batteries
■
One sensor connection cable per channel
■
Calibration report 3.1according DIN EN 10204 for pressure sensor
■
Pressure sensors as selection
■
Cross-check scope of delivery with delivery note.

5 Transport, packaging and storage

5.1

Transport

Check the Hand-Held Pressure Indicator model CPH6300 for any damage that may have been
caused by transport. Obvious damage must be reported immediately.
5.2

Packaging

Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change in
installation site, sending for repair).
5.3

Storage

Permissible conditions at the place of storage:
Storage temperature: -25 ... +70 °C
■
Relative Humidity: 0 ... 95 % r. H. (non-condensing)
■
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Potentially explosive environments, flammable atmospheres
■
Store the gauge in its original packaging in a location that fulfills the conditions listed above. If the
original packaging is not available, pack and store the gauge as described below:
1. Wrap the gauge in an antistatic plastic film.
2. Place the gauge, along with shock-absorbent material, in the packaging.
3. If stored for a prolonged period of time (more than 30 days), place a bag, containing a
desiccant, inside the packaging.
WARNING!
Before storing the gauge (following operation),
remove any residual media. This is of particular importance if the medium
is hazardous to health, e.g. caustic, toxic, carcinogenic, radioactive, etc.
WIKA Operating Instruction, Model CPH6300
GB
11