Motor Connection - Lenze 8200 motec Montageanleitung

efesotomasyon.com - Lenze
{
Danger!
After the connection of a PTC thermistor or thermal contact
l
all control terminals only have a basic insulation (single
insulating distance).
Protection against contact in the event of a defective
l
insulating distance can only be ensured by external measures
(e.g. double insulation).
(
Stop!
Terminal X2 and sheet must not be disconnected!
!
3.4 Nm
30 lb-in
5.5 mm
X2
Use low−capacity motor cables! (Core/core £75 pF/m, core/shield £150 pF/m)
0
The shorter the motor cable used, the better the drive behaviour!
Cable cross−sections U, V, W, PE:
E82MV251_2B
E82MV371_2B
1
For motor temperature monitoring, use a separate cable (shielded) for X2/T1 and X2/T2.
Route the control and mains cable separately from the motor cable!
L
A
B
X2
1a
® 1 mm
2
(AWG 18), shielded
® 1 mm
2
(AWG 18), shielded
EDK82MV371 DE/EN/FR 6.0
Wall mounting

Motor connection

0.5...0.6 Nm
4.4...5.3 lb-in
W V U PE T2 T1
5.5 mm
PE
3
2
2.5 mm
AWG 12
6mm
X2
T2 T1
ϑ >
−11−8200mot052
85