Lenze 8200 motec Montageanleitung Seite 72

1
Safety instructions
Lenze controllers
Transport, storage
Please observe the notes on transport, storage and appropriate handling.
Observe the climatic conditions according to EN 50178.
Installation
The controllers must be installed and cooled according to the regulations
given in the documentation.
Ensure proper handling and avoid mechanical stress. Do not bend any
components and do not change any insulation distances during transport
or handling. Do not touch any electronic components and contacts.
Controllers contain electrostatically sensitive components which can easily
be damaged by inappropriate handling. Do not damage or destroy any
electrical components since this might endanger your health!
Electrical connection
When working on live drive controllers, the applicable national regulations
for the prevention of accidents (e.g. VBG 4) must be observed.
The electrical installation must be carried out according to the appropriate
regulations (e.g. cable cross−sections, fuses, PE connection). Additional
information can be obtained from the documentation.
The documentation contains information about installation in compliance
with EMC (shielding, earthing, filters and cables). These notes must also be
observed for CE−marked controllers. The manufacturer of the system or
machine is responsible for the compliance with the required limit values
demanded by the EMC legislation.
Operation
If necessary, systems including controllers must be equipped with
additional monitoring and protection devices according to the
corresponding standards (e.g. law on technical equipment, regulations for
the prevention of accidents, etc.). If necessary, adapt the controllers to your
application. Please observe the corresponding information given in the
Instructions.
After the controller has been disconnected from the supply voltage, live
components and power connection must not be touched immediately since
capacitors could be charged. Please observe the corresponding notes on
the controller.
All covers and doors must be closed during operation.
Note for UL−approved systems with integrated controllers: UL warnings
are notes which apply to UL systems. The documentation contains special
information about UL.
70
efesotomasyon.com - Lenze
EDK82MV371 DE/EN/FR 6.0
L