Relay Output Connection - Lenze 8200 motec Montageanleitung

4
Electrical installation

Relay output connection

1a
Function
X1/K11 NC contact relay output
X1/K12 Relay middle contact
X1/K14 NO contact relay output
PES HF screen termination by PE connection with a surface as large as possible
)
Note!
For switching the control signals use shielded cables and
l
establish an HF shield termination by PE connection.
For mains potential switching unshielded cables are
l
sufficient.
With inductive or capacitive loads a corresponding protective
l
circuit is required in order to protect the relay contacts!
The service life of the relay depends on the type of load
l
(ohmic, inductive or capacitive) and the value of the switching
capacity.
The output message can be changed under C0008 or
l
C0415/1.
94
efesotomasyon.com - Lenze
Fig. 22
X1
Relay position
set
open
closed
EDK82MV371 DE/EN/FR 6.0
Message
Technical data
(Lenze setting)
TRIP
AC 250 V/3 A
DC 24 V/2 A ... DC 240 V/0.22 A
TRIP
8200 motec
X1 K11 K12 K14
PES
PES
8200mot058
L