Connecting A Headset; Important Information On The Location Of The Telephone - Auerswald COMfortel 1600 Inbetriebnahmeanweisungen

Connecting a Headset

Requirements
• COMfortel 1600: a wired headset corresponding to the technical data listed on
• COMfortel 2600: a headset corresponding to the technical data listed on
Note: The COMfortel 2600 supports the operation of cable-connected headsets as well
as cordless headsets (headsets with a DHSG interface, for example, from Auerswald,
Jabra, or Plantronics).
• COMfortel 2600 only: to connect a COMfortel headset from Auerswald or another cable-
connected headset, you require: an adapter (already included in the scope of supply of
COMfortel headsets).
Note: The adapter
www.districom.de). Delivery is provided only within Germany and Austria.
1. Insert the headset connector into the socket labelled with
telephone.
2. Guide the cable to the outside using the corresponding cable channel.
Further Steps
• COMfortel 2600 only: after commissioning, select the headset type that is being used (in
settings > headset > headset type).
• In order to use the headset for calls, enable headset operation at the end of commission-
ing (in functions > headset).

Important Information on the Location of the Telephone

Requirements
• Existing connections in the immediate vicinity of where the telephone is placed:
– ISDN socket outlet connected to the PBX
COMfortel 1600/2600 - Firmware V1.8 - COMfortel Set V3.10.0 - Setup V07 09/2016
can be bought in the Internet
Preparation
page
page 38.
shop distriCOM
on the lower side of the
38.
(see
45