Changing The Drive Belt - Cocraft HB 10-L Bedienungsanleitung

Changing the drive belt

1. Remove the blade. Refer to the section
Changing the saw blade.
2. The motor is fastened by two bolts on
the back of the saw.
3. Undo the two bolts so the motor can be
moved and the belt loosened.
5. Pull the blade pulley wheel off the shaft.
6. Place the new belt over the motor's drive
pulley wheel and round the shaft which
the blade pulley wheel is mounted on.
Replace the blade pulley wheel and refit
the circlip. Check that the drive belt is
correctly positioned in the pulley grooves.
Note:
• Always unplug the bandsaw before making any adjustments or repairs and whenever
the saw is not to be used.
• Do not expose the product to moisture.
• Keep the table clean and free of wood sap.
• Keep the product clean, using a brush and dust extractor to remove dust and sawdust.
Pay particular attention to the motor's cold air intakes and any openings around the blade
where the dust can build up and prevent the blade from running freely.
4. To replace the drive belt the lower blade
pulley wheel must be removed. Find
the circlip that holds the blade pulley wheel
onto the shaft and remove it using a pair of
circlip pliers.
7. Tension the belt by pivoting the motor back
into place and secure it with the two bolts.
16