Cocraft HB 10-L Bedienungsanleitung Seite 4

21. Warning:
- The use of any accessory or attachment other than one recommended in this instruction
manual may present a risk of personal injury.
22. Have your tool repaired by a qualified person.
- This electric tool complies with the relevant safety rules. Repairs should only be carried out
by qualified persons using original spare parts, otherwise this may result in considerable
danger to the user.
Specific safety instructions for band saws
• If using a floor stand, make sure that the product is securely fastened to the stand and that
the stand is properly assembled and securely fastened to the floor.
• Make sure that the product is positioned in such a way that the workpiece can be worked on
in a safe manner.
• This saw must not be used for wet cutting. Doing so can lead to deadly electric shocks.
This band saw is only intended for dry cutting.
• The drive belt must not be put under too much tension, it will last longer if the tension is
released when the saw is not in use.
• Do not allow the build-up of sawdust around the motor or inside the product. Piles of sawdust
are a fire hazard.
• The sawblade must not be stopped through the exertion of pressure on the workpiece or by
applying force to the sides of the blade.
• The product's safety guards must be in place and functioning properly. Always check that
the blade guides are correctly aligned.
• Never turn the product on if the saw blade is in contact with the workpiece.
• Make sure that there are no nails or screws in the workpiece which could damage the saw blade.
• Do not attempt to modify the product or its accessories in any way.
• Do not apply too much pressure to the workpiece when feeding it into the saw blade.
A steady feed rate reduces wear on the saw and saw blade and consequently increases
the efficiency and useful life of the band saw. Replace any worn table inserts.
• Connect the product to a dust extractor before starting to saw. The saw must not be used if
any of its panels are open.
• Adjust the saw blade to the workpiece being worked on.
• When sawing with a tilted table, position the guide on the lower side of the table.
• Position the blade guard as close to the workpiece as possible.
• Never use damaged or deformed saw blades.
• Replace the table insert when it is worn or damaged.
• Do not clean the product whilst it is in operation.
• Connect a dust extraction device to the product when sawing wood.
• Do not turn the saw on when one of the blade pulley wheel covers is open or if any of
the blade guards are not in place.
• Make sure that you use the correct feed rate for the material that is to be cut.
4