Cocraft HB 10-L Bedienungsanleitung Seite 12

Installing the mounting rail
Secure the mounting rail (E) on the table (C) using
the wing screws (HP4) and flat washers (HP5).
Adjusting the table trunnion
B
A
The tilt of the table in its end position is normally adjusted to lie vertically (90°) against the saw blade.
1. Unlock the trunnion using the handle (A) and turn the table so it rests against the table stops (C).
2. Place a try square (E) on the table and check that the tilt to the saw blade is 90°.
If the slope is not 90°, adjust as follows:
a) Tilt up the table so that you can access the table stops (C).
b) Loosen the lock nut (D) and screw the table stops in or out. Retighten the lock nut.
c) Tilt back the table and check the tilt as in point 2.
d) Check that the scale indicator (F) is pointing towards 0 by:
e) Angling the table at 90° to the saw blade.
f) If necessary, loosen the screw holding the pointer and turn it until it points towards 0.
Retighten the screw.
E
HP5
HP4
D
C
G
12
C
E
F
A