Manual Operation; Handling - Renkforce Matrix Beam Moving Head 9 x 12 W Bedienungsanleitung

i) Manual Operation
• In the menu, select Manual Control and push the ENTER (11) button.
• Select the desired menu times with the UP (10) or DOWN (13) buttons and push the ENTER (11) button.
• Set the desired DMX values with the UP (10) or DOWN (13) buttons and push the ENTER (11) button to save.
- Pan = swivel position
- Tilt = tilt position
- XY Speed = movement speed
- Dimmer = total brightness
- Strobe = strobe speed
- Red = brightness red
- Green = brightness green
- Blue = brightness blue
- White = brightness white

12. Handling

• Never connect the mains plug to a mains socket immediately after the device has been taken from a cold to a warm
environment. The resulting condensation may destroy the device. Allow the device to reach room temperature
before connecting it. Wait until the condensation has evaporated.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the intended
grip areas.
• Unplug the mains plug from the mains socket if you are not using the device for an extended period of time.
• Disconnect the mains plug from the mains socket during thunderstorms for reasons of safety.
• Never put any filter foils, masks or other materials over the light exit. This may cause heat damage and danger of
fire.
• The device may heat up during operation. Never touch the casing during operation. Let the effect light cool off after
operation before touching or cleaning the casing.
• Do not cover the device to ensure sufficient ventilation. Air circulation and the movement of the projector head
must not be impaired by objects such as magazines, tablecloths, curtains, etc. During operation, keep a minimum
distance of 0.5 m around the device.
• The device is not suitable for continuous operation. Consistent compliance with operating breaks (every 8-12 hours)
extends service life. Let the device cool off for some time before starting it up again (approx. 2 hours).
42