D) Sound-To-Light Mode; Master-Slave Mode - Renkforce Matrix Beam Moving Head 9 x 12 W Bedienungsanleitung

d) Sound-to-Light Mode

• In the menu, select Run Mode and push the ENTER (11) button.
• Select the operating mode Sound Control with the UP (10) and DOWN (13) buttons.
• Press the ENTER button (11) to confirm your selection.
Setting of the microphone sensitivity
• In the menu, select Advanced Setup and push the ENTER (11) button.
• Select the menu item Mic Sensitivity with the UP (10) and DOWN (13) buttons.
• Press the ENTER button (11) to confirm your selection.
• Set the microphone sensitivity with the buttons UP (10) or DOWN (13) (000=min. / 100=max.).
The device is controlled via the installed microphone in time with the music in this mode.
Set the microphone sensitivity so that the light effect changes in time with the music.
e) Master-Slave Mode
Only one device in a master-slave-chain must be defined as master device. All other devices must be
defined as slave devices.
Master mode with automatic programs
• In the menu, select Run Mode and push the ENTER (11) button.
• Select the operating mode Master Auto Run with the UP (10) and DOWN (13) buttons.
• Press the ENTER button (11) to confirm your selection.
• Select the desired automatic programme (Perform Mode 1-8) with the UP (10) and DOWN (13) buttons.
• Press the ENTER button (11) to confirm your selection.
Master mode in sound-to-light mode
• In the menu, select Run Mode and push the ENTER (11) button.
• Select the operating mode Master Sound Control with the UP (10) and DOWN (13) buttons.
• Press the ENTER button (11) to confirm your selection.
Set the microphone sensitivity as described in "Sound-to-light Mode".
Slave Mode
• In the menu, select Run Mode and push the ENTER (11) button.
• Select the operating mode Slave Run with the UP (10) and DOWN (13) buttons.
• Press the ENTER button (11) to confirm your selection.
39