Operation; Setting The Operating Mode - Renkforce DL-LED162 Bedienungsanleitung

10. Operation

a) Setting the operating mode
The effect light can be controlled with the integrated controller or with an external DMX controller. Ad-
ditionally, it can be used as a master device with integrated controller to control other connected effect
lights synchronously in master-slave operation, or as slave device via the controller of another DL-LED162
effect light.
Use the LED display and function buttons MODE, ENTER, UP and DOWN to set the operating mode.
• Push the button MODE to choose the setting mode.
• Push the button ENTER to choose the submenu.
The display automatically returns to the MODE setting after a few seconds.
• Select the desired setting/operating mode with the UP and DOWN buttons.
The DMX connection takes precedence. If an active connection to a DMX-controller has been
created, the buttons on the rear of the device can only be used to set the DMX address, the slave
settings and the DMX mode (Ch2 or Ch9).
The following table shows the effects of the settings.
MODE ENTER
A001-A512 A001-A512
2CH / 9CH
SL 1 / SL 2
So01-So30 So01-So30
AU01-AU30 AU01-AU30
SP01-SP99
Led Led
Leon-LeoF
28
UP / DOWN
DMX address
DMX mode
SL 1, slave function, effect analogue master
SL 2, slave function, effect reverse to master
Sound Control Programmes
Auto Programmes
Speed control for audio programmes
Display orientation is rotated
Leon = LED display steady light
LeoF = LED display switches off after approx. 20 sec. if a key is not
pressed any more. Press any key to activate the display.