Troubleshooting; Disposal - Renkforce Matrix Beam Moving Head 9 x 12 W Bedienungsanleitung

14. Troubleshooting

By purchasing this effect light, you have acquired a product designed to the state of the art and operationally reliable.
Nevertheless, problems or errors may occur. Therefore, we would like to describe how to eliminate possible errors
here:
Always observe the safety information!
No function after the device has been connected to the power supply grid
• The mains plug is not plugged into the socket correctly.
• The mains line is not properly plugged into the mains connection of the device or is not properly latched.
• The mains socket is not supplied with current.
• The device is off.
There is no reaction to DMX commands
• The blackout mode is activated at the DMX controller.
• The DMX address is set wrongly.
• The connection between the DMX controller and the effect light is interrupted.
• The DMX line is too long or subject to interference. Use a special DMX high frequency line. Try placing the DMX
line away from the interference source.
• The polarity of the DMX connections to the DMX controller and effect lights are different.
• If possible, try another DMX controller.
The music control does not work
• Music control is not activated.
• Music playback volume is too low. Try setting a higher volume or increasing the microphone sensitivity.
• Test the function of the installed microphone by tapping a finger on the housing. The sound-to-light control should
react to these impulses.

15. Disposal

Electronic devices are recyclable waste and must not be disposed of in the household waste!
Dispose of the product according to the applicable statutory provisions at the end of its service life.
44