Discharging The Grease Separator; Discharging The Sludge Trap - Kessel NS 4 Anleitung Für Einbau, Bedienung Und Wartung

4.4.1 Discharging the grease separator

Risk of burns
protective equipment (gloves, spray protection, etc.).
If no grease or wastewater emerges, the grease is not fluid enough, and the heating time must be extended
(see 4.4) or the fill level of the sludge container is too low. Remedy: Fill the sludge container completely.
Make sure that the heating cover has been heated for the necessary period of time.
1. Place an empty collection barrel in position.
2. Make sure that the collection barrel connected to the grease separator <22> is empty.
3. Open the discharge valve <27>, and the grease flows into the collection barrel.
4. If wastewater is visible in the transparent discharge hose <48> instead of grease, close the discharge
valve <27> and continue with Step 7.
5. If the volume flow in the transparent discharge hose <48> has come to a standstill (collection barrel is full),
close the discharge valve <27>.
6. Loosen the cover clamping ring <50> so that the air can escape from the collection barrel <22>; the remaining
grease will then flow into the collection barrel.
7. Remove the cover from the collection barrel and fit the cover onto the empty collection barrel using the cover
clamping ring.
8. Empty the full collection barrel (subject the contents to proper disposal).
9. Repeat the entire procedure.

4.4.2 Discharging the sludge trap

Filling the collection barrels for a) sinking sediments and b) floating scum is carried out according to the same
functional principle (fig. [28]) as discharging the grease separator.
V 1.0
Operating mode
There is a risk of burns in the event of contact with the liquid and heated grease. Wear personal
27
48
50
22
fig. [10]
61 / 80