Operating Mode; Switching On; Setting The Disposal Interval, Heating And Mixing Time - Kessel NS 4 Anleitung Für Einbau, Bedienung Und Wartung

4

Operating mode

4.1

Switching on

Following a successful function check, the grease separator may be
switched on; to do so:
• Switch on the main switch. After a successful system test, the dis-
play <65> shows the
lights up, indicating that the grease separator is ready for operation.
If the 3.8.1 Language menu is displayed after switching on, carry
out initialization (see 3.4.1).
4.2

Setting the disposal interval, heating and mixing time

The disposal interval is designed to ensure the regular discharging of the grease separator. Depending on the
volume of grease in the wastewater, the length of the interval may vary. The grease separator must have been
heated up for at least 2 hours before any disposal, so that the collected grease can flow out.
If disposal is carried out late, the operational reliability of the grease separator cannot be guaranteed.
To ensure that the grease is discharged as completely as possible, the grease in the grease separator is mixed
by the mixer motor (option) or with the mixer crank immediately before discharge. If a mixer motor is present, the
duration of the mixing time can be set.
The following parameters have been set as default for normal operation (disposal interval daily).
60 Heating time
61 Sludge return*
62 Mixer motor*/Hand crank**
* Option ** Crank revolution 1 to 2 times per second
Operating mode
menu and the green LED <64>
0 System info
61
2 hours
10 seconds
10 minutes
58 / 80
65
60
fig. [9]
Heat the heating cover of the grease separator
Pump sludge from the grease separator into the sludge
trap.
Mixing of the grease
Fettabscheider/Grease Seperator „SE"
fig. [8]
62
64
V 1.0