Discharging The Grease Separator; Discharging The Sludge Trap - Kessel NS 2 Anleitung Für Einbau, Bedienung Und Wartung

4.3.1 Discharging the grease separator

Risk of burns
protective equipment (gloves, spray protection, etc.).
,I QR JUHDVH RU ZDVWHZDWHU HPHUJHV WKH JUHDVH LV QRW ÁXLG HQRXJK DQG WKH KHDWLQJ WLPH PXVW EH H[WHQGHG
VHH  RU WKH ÀOO OHYHO RI WKH VOXGJH FRQWDLQHU LV WRR ORZ 5HPHG\ )LOO WKH VOXGJH FRQWDLQHU FRPSOHWHO\
Make sure that the heating cover has been heated for the necessary period of time.
1. Place an empty collection barrel <22> in position.
2. Make sure that the collection barrel connected to the grease separator <22> is empty.
3. 2SHQ WKH GLVFKDUJH YDOYH ! DQG WKH JUHDVH ÁRZV LQWR WKH FROOHFWLRQ EDUUHO
4. If wastewater is visible in the transparent discharge hose <48> instead of grease, close the discharge
valve <27> and continue with Step 7.
5. ,I WKH YROXPH ÁRZ LQ WKH WUDQVSDUHQW GLVFKDUJH KRVH ! KDV FRPH WR D VWDQGVWLOO FROOHFWLRQ EDUUHO LV IXOO 
close the discharge valve <27>.
6. Loosen the cover clamping ring <50> so that the air can escape from the collection barrel <22>; the remaining
JUHDVH ZLOO WKHQ ÁRZ LQWR WKH FROOHFWLRQ EDUUHO
7. 5HPRYH WKH FRYHU IURP WKH FROOHFWLRQ EDUUHO DQG ÀW WKH FRYHU RQWR WKH HPSW\ FROOHFWLRQ EDUUHO XVLQJ WKH FRYHU
clamping ring.
8. Empty the full collection barrel (subject the contents to proper disposal).
9. Repeat the entire procedure.
NS 2-10

4.3.2 Discharging the sludge trap

)LOOLQJ WKH FROOHFWLRQ EDUUHOV IRU D VLQNLQJ VHGLPHQWV DQG E ÁRDWLQJ VFXP LV FDUULHG RXW DFFRUGLQJ WR WKH VDPH
IXQFWLRQDO SULQFLSOH ÀJ >@ DV GLVFKDUJLQJ WKH JUHDVH VHSDUDWRU
Operating mode
There is a risk of burns in the event of contact with the liquid and heated grease. Wear personal
27
48
50
22
NS 15-20
ÀJ >@
62 / 80
27
48
50
22
2016/05