Explanation Of Led Signal Lamps - Schaerer 062'011 Bedienungsanleitung

SCHAERER OPAL
Control panel
1 On/Off button
1a Ready mode indicator (green)
1b Stand-by mode indicator
2 Cleaning/rinse & descaling button
2a Cleaning/rinse & descaling indicator
3 Coffee pot selection button
3a Coffee pot selected indicator
4 Ground coffee select button
4a Ground coffee select indicator
5 +/- button for setting quantities
5a 1-6 programmed setting indicator
6 Programming button
6a Water quantity programming selected indicator
6b Coffee quantity programming selected indicator
7 Single cup espresso selection button
7a Single cup espresso selected indicator
8 Single cup regular coffee selection button
8a Single cup regular coffee selected indicator
9 Two cups espresso selection button
9a Two cups espresso selected indicator
10 Two cups regular coffee selection button
10a Two cups regular coffee selected indicator
11 Temperature indicator (green)
12 Water low indicator (red)
13 Coffee beans low indicator (red)
14 Grounds container full indicator (red)
15 Brewer malfunction indicator (red)
16 Descaling indicator (red)
BAOP - 02 - V04

Explanation of LED signal lamps

1-6 This indicates the values you have set on a scale of 1 to 6 for the required
coffee quantity, temperature, standby and status ê
This signal lamp remains lit when you are programming the water quantity
ê 6a
This signal lamp remains lit when you are programming the coffee quantity ê
6b
This lamp indicates that the correct operating temperature has been
reached ê 11.
This lamp flashes when the level in the water tank falls too low or if the tank
has been removed ê 12.
This lamp remains lit when the pump stops drawing water. If this happens,
you need to remove the air from the system ê
sible malfunctions no. 4 for guidance on how to do this.
This lamp remains lit when the coffee beans container is empty. It goes out
automatically as soon as the container is refilled and coffee is selected
ê 13.
This lamp flashes if you take the lid off the coffee beans container or do not
replace it correctly ê 13.
+1 This lamp also remains lit if the grinding unit is jammed ê
guidance on clearing the blockage, see section 12.3.
This lamp remains lit when the coffee grounds container is full and extin-
guishes automatically when the container is emptied and replaced ê
This lamp flashes when the coffee grounds container is not in positionê
14.
This lamp flashes if the brewing unit is inserted incorrectly or the service
hatch is not closed correctly ê
This lamp remains lit whenever a serious fault arises. If this happens,
request assistance from an authorised specialist ê
This lamp flashes to indicate that you need to run the regular cleaning cycle
(after every 250 cups of coffee) ê
This lamp remains lit during the cleaning and rinse cycles ê
This icon indicates the need for descaling. It goes out as soon as the
descaling programme is finished ê
Standby mode indicator - this lights up red when the appliance is switched
from Ready to Standby mode by means of the mode selector switch. The
appliance requires very little power in Standby mode ê
Lights up whenever a fault arises. If this happens, request assistance from
an authorised specialist ê
User instruction
5a.
12.• See section 14.0 Pos-
15.
15+5a.
2a.
2a.
16.
1a.
12+15. • See section 14.0 Possible.
13+5a. • For
14.
Page 53