PCE Instruments UA964801 Betriebshandbuch Seite 65

For the calibration procedure refer to the following table:
Press
1
2
3
4
0
Display
Set the value on minimum.
Set the value to maximum.
Set the virtual zero value.
To use the LATCH ON function: enter
configuration, select Setting on par.
8 Latch on and press
shows the page in the picture).
Place the sensor on minimum
operating value (associated
with Lower limit V/I).
Place the sensor on maximum
operating value (associated
with Upper limit V/I).
To exit standard procedure
press Esc
For zero settings place the
sensor on the zero point
Press Esc
Min
Sel (UA964801
Do
.
to exit procedure.
Max
Nullpunkt/Zero
User manual - UA964801
65