Flyer C SERIE Anleitung Seite 233

Blinking Description
pattern of
charger LED
Charging
ror
An .error .has .
occurred in
Blinking red
the battery
or .charger. .
Charging
cannot be
continued.
1 Remove the rubber cap
Open .the .rubber .cap .on .the .battery. .Connect .the .
mains . p lug . t o . a . m ains . s ocket . ( 220 . V . – . 2 40 . V . A C) . a nd
connect .the .charger .to .the .battery.
During .charging, .the .following .messages .may .be .displayed .by .the .battery .and .charger .via .LEDs:
Operation
Connect the power source plug of the
charger .into .the .wall .socket.
Connect the charger plug to the charging
terminal.
Charging
Charging completed
Action
er- Remove any
dirt from the
terminals and
plugs. .If .the .
problem per-
sists, contact
your .FLYER .
specialist
retailer.
Status
Normal .charging
33
Do not connect the charger to the mains
socket immediately after a sudden tem-
perature .change .from .cold .to .warm. .It .is .
possible that condensed water has col-
lected on the contacts and this will lead
to .a .short .circuit.
Do not connect the battery to the charg-
er immediately after a sudden tempera-
ture . c hange . f rom . c old . t o . w arm. . W ait . u ntil .
both devices have reached room tem-
perature before connecting the charger
or .the .battery. .Always .charge .and .store .
the battery and the charger in a dry and
clean .environment.
2 Check the LED charge status indicator
Check . whether . the . charge . status . LED . is . lit . up. .
The .LED .lights .up .according .to .the .charge .status. .
The .charge .status .LED .goes .off .when .the .charg-
ing . process . has . been . completed. . The . charging .
time takes longer if the battery temperature is too
low .or .too .high.
A . fully . charged . battery . cannot . be . charged . any .
further.
Battery level indi-
cation lamp
-
Off
Lighting .(battery .
level indication)
Off
EN
Charger
LED
Off
Blinking
green
Lighting .
green
Off