Flyer C SERIE Anleitung Seite 212

In .the .settings .menu, .select .the ."Calibrate .Nuvin-
ci" .submenu .by .clicking .the .OK .button.
Now . press . the . OK . button . again . to . start . the . ca-
libration.
The system can only calibrate successfully if you
pedal lightly or with no force throughout the pro-
cess. .A .confirmation .message .will .appear .on .the .
display .if .the .calibration .has .been .successful.
NuVinci H/SYNC control
2.
3.
1.
The . NuVinci . gear . system . is . controlled . with . the .
remote .RC1. .Button .2 .can .be .used .to .switch .bet-
ween .manual .and .cadence .mode.
In . manual . mode, . there . are . 12 . gears . (when . the .
X1 motor is used) or 9 gears (when the X0 motor
is .used) .to .choose .from. .Use .button .3 .to .go .up .a .
gear . and . button . 1 . to . go . down . a . gear. . Pressing .
and holding the button enables you to change th-
rough .several .gears .at .once.
In .cadence .mode, .the .same .buttons .can .be .used .
to .adjust .the .cadence. .It .is .increased .or .decrea-
sed .by .5 .revolutions .per .minute.
1. .Currently .selected .gear .(manual .mode)
12