Trimming The Quadrocopter - Reely 1576770 Bedienungsanleitung

j) Trimming the quadrocopter
Start up the transmitter first, then the model.
Press the start button so that the quadrocopter climbs to a sufficient height.
If you then realize that the quadrocopter wants to fly in a particular direction without any command from the transmit-
ter, correct the flight behaviour by trimming.
Every time a trim button is pushed, the trim is adjusted by one step and the adjustment confirmed by a short
beep.
When the button is pressed down for more time, the transmitter emits a quick sequence of beeps, and thus
indicates the step-by-step adjustment of the trim.
Once the trim's end position is reached, no more beeps are emitted by the transmitter.
The trim's centre position is indicated acoustically by a longer beep.
If you subsequently have the quadrocopter securely under control, you can also optimally adjust the trim during flight.
Roll trimming:
If the quadrocopter drifts or tips sideways to the right, reduce the speed until the quadrocopter once more stands
safely on its landing feet. Press the trim button for the roll function (see also Figure 1, no. 5) to the left several times.
Then carefully push the pitch joystick forward again and check whether the adjustment was sufficient. Repeat the
procedure until the model does not show any tendency to drift to the right.
If the quadrocopter wants to drift sideways to the left, press the trim button for the roll function to the right.
Figure 16
69